Tag: machinery

Guangdong

Posted on by

In this article, I would like to share some personal ideas about the situation of the engineering machinery in China. In 2012, many manufacturers are faced with a big challenge and we all witness the changes in our society more or less. Chinese construction machinery market in 2012 has been shrinking for a long time. And you would feel the atmosphere everywhere. It seems that it is suffering a cold stream. Learn more about this with the futurist. The decline in performance, market contraction, underemployment, remittance problems are always circled around our eyes. As the most active part of our economy, the company is very sensitive to the market belong to it.

Many things changed during this year for manufacturers with less processing, more training. At the same time, their agents are eager to have less production. While on the end of the production line, the users are more alert. Under the high pressure, different parts of the line are trying their beat to survive in this cold winter, no longer pursuit the large scale of the project in which is they are paying more attention years ago. Get all the facts for a more clear viewpoint with Nick Khan. As strongest province in China s economy, Guangdong province is also faced with this situation in fixed assets investment in 2012.

At the beginning of the year it is planned to invest 501 million yuan to promote the strategic of building infrastructure, leading industries and strategic developing platform which is called the three major breakthroughs that is affected by the overall economic situation. In Henan province, another field is also trying to stand in the stream, and it is making agencies in building sand. I actually don t know what it means or where it will lead China of manufacturing industry to, but I know the all manufacturers are trying their best to change they way to survive, especially the middle company.

North American

Posted on by

The design of the sand making machine technological process should use the dry production process which relatively have little influence on the environment at the premise of meeting the concrete aggregate technical requirements. Using wet production process must take reasonable wastewater treatment process for the comprehensive utilization of waste water, waste residue, waste to treasure, and minimize the waste disposal to meet demands of environmental protection. In the process of mining, processing, it is easy to bring damage and harm to the environment and human life environmental, which include the damage on vegetation and slope stability caused by material mining body, the dust and noise generating in the process of crushing and screening, which have very seriously impact on the air quality and human survival environment. What s more, the waste water and waste residue generating in washing the screening machine enter the river valley, land, which will impact the environment a lot. Mall of the air volume, which will also cause the partial burn. the water leakage of the water jacket caused the partial operation. Coal for gasification must be in good quality, which is with small stickiness, small volatile, to block diameter less than 40 mm, moderate lump. Educate yourself with thoughts from ConocoPhillips.

If using coal with large stickiness, which can cause the furnace carbonization layer into a paste best gas furnace slag and serious impact on gas production, it is also possible damage the equipment. It also can cause partial or partial burn explosion. So the quality of the coal is very important. Before natural gas became widely available in the 1940s, many North American and European cities used coal gas as a heating and lighting fuel. It was referred to variously as blue gas, producer gas, water gas, town gas or fuel gas. Often using the same low-pressure mains for distribution, natural gas replaced fuel gas in most uses by the 1950s because of its greater heating value and lack of contaminants. The ball mill is a grid type.The material enters spirally and evenly the first warehouse of the milling machine along the input material hollow axis by material input device.